Right Angle Building Board Clamps

The design of the clamp makes it very rigid. The clamps just slot together during the assembly add a minimal amount of your preferred glue., mine is PVA. I use a toffy hammer to tap them together tight.

The clamp has a tall side which measures 195 mm approximately 7 3/4" and a shorter not so tall side measuring 155 mm approximately 6". The slot in the centre of the clamp is an" M 4" bolt size 4.2 mm in diameter, and can early be relieved to take an M 5 bolt.  I can make the slot up to m6 just specify the shot size with your order. 

1 sheet of cut ply is 2 clamps  so they are sold as a pair

I designed these clamps specifically to accommodate the depth of the front of the Northstar fuselage but can be used with any other fuselage on your building board.

Orders  will be sent out flat packed see picture 4

Some links to Northstar sites of interest  Northstar Delta Facebook  Nortystar RC models Facebook